Remove Probe - Emerson Rosemount Oxymitter DR Reference Manual

Maintenance and service
April 2022
4.2.1 Calibration record
Probe serial number:
Probe tag number:
Probe location:
Date placed into service:
4.3

Remove probe

Refer to
items in that figure.
Procedure
1. Turn off power to the system.
2. Shut off the calibration gases at the cylinders and instrument air.
3. Disconnect the calibration gas and instrument air lines from the transmitter.
4. While facing the probe and looking at the Rosemount label, remove screw (25),
48
Figure 2-10. The numbers in the steps below correspond to the numbers of the
gasket (26), and cover lock (27) securing left housing cover (20). Remove the cover
to expose the terminal block (Figure 2-11).
Reference Manual
00809-0100-4884
Emerson.com/Rosemount