ElectrIQ eiQCHC60W User Manual page 9

8. Adjust the height of the chimney to
approximately the required height.
Then install plate I on the chimney.
Two screws (4mm x 8mm) are used.
i Put the inner chimney into the outer
chimney. Then pull the inner chimney
upwards. Adjust to reach the
approximate height required. Fine
height adjustment is done later.
ii. Install plate I on the chimney
NOTE: Remember not to fix the screw too tightly, so that later height
adjustment can be done more easily.
10. Pull up the inner chimney and fix it into
inner chimney bracket with 2 x screws (4mm
x 8mm).
9. Fix the chimney set into the chimney bracket
and fix with 2 x Screws (4mmx8mm), then fix
the outer chimney bracket into wall with 2 x
screws (4mm x 40mm), pull out the exhaust
pipe to outside.
9