Setting The Width Of The History Marker - Furuno FSV-84 Operator's Manual

6.3.3

Setting the width of the history marker

You may set the width of the history marker as follows:
1. Press the [MENU] key to open the menu.
2. Select OTHERS and press the [MENU] key.
3. Select DISPLAY SETTING and press the [MENU] key.
4. Select H-SLICE WIDTH and press the [MENU] key.
5. Use the trackball to select 1, 2, 4, 8, 16 or 32 as appropriate and press the
[MENU] key.
The numeric options are the number of display dots. For example, "16", the
default setting, extracts 16 dots from the horizontal display.
6. Select QUIT and press the [MENU] key.
7. Select QUIT at the top of the menu screen and press the [MENU] key to
close all menus.
MENU
OTHERS
DISPLAY SETTING
DISPLAY MODE...
MODE SELECTION : MODE KEY
TX/RX MODE : ALTERNATIVE
H2/S DISPLAY : LANDSCAPE
PRESENTATION MODE : HEAD UP
TM DISPLAY RANGE : 1.6R
BEARING REF : SHIP HEADING
TILT LEVER : TILT
S AUTO OFF CENTER : OFF
H-SLICE WIDTH : 16
H-SLICE PICT ADVC : KP SYNC
NET COURSE MARK : ENTER
MANUAL DEGAUSS : EXECUTE
AUTO DEGAUSS : INT SENSOR
DIMMER : 10
KEY BEEP VOLUME : 5
DISPLAY SETTING menu
QUIT
CANCEL
1
2
4
8
16
32
Horizontal slice width dialog box
6. HISTORY MODE
QUIT
QUIT
QUIT
6-5