Table of Contents
Advertisement
Interpreting the board test results
• Board name and its revision no. are shown in white. If a board is not
inserted or inserted improperly "F" is shown as program number. When a
revision no. is improper a hexadecimal from 0-E appears. When an error is
found, revision no. and board name appear in red.
• Program no. is shown in white, or red when software finds revision no. error.
• DIP switch setting on each board is shown.
• Memory read/write test results are shown as OK (white) or NG (red).
• Test data check results are shown as OK (white) or NG (red).
• TX +B voltage is measured and displayed.
• Motion sensor test results show OK (white) or NG (red) as overall results
and pitch and roll angles.
• KEY 2-0 will be displayed only when two control units are installed.
11. MAINTENANCE, TROUBLESHOOTING
11-9
Advertisement
Table of Contents
Troubleshooting
