2.10
Adjusting Beamwidth
The horizontal beamwidth of the Rx beam can be adjusted at the OTHERS
menu as below to raise the horizontal resolution.
1. Press the [MENU] key to open the menu.
2. Select H-SCAN SETTING and press the [MENU] key.
3. Select OTHERS and press the [MENU] key.
4. Select BEAMWIDTH and press the [MENU] key to open the dialog box.
5. Select BEAMWIDTH A and set appropriate value. The higher the setting the
sharper the horizontal resolution. The setting range is -4 to 5 plus AR and the
default setting is 0. AR means AUTO RANGE and it automatically adjusts
horizontal beamwidth according to the range.
6. Select BEAMWIDTH B and set appropriate value. This controls echo beam
width by echo processing. The setting range is 0-5, and the higher the setting
the greater the horizontal resolution.
7. Select QUIT and press the [MENU] key.
8. Select QUIT at the top of the menu screen and press the [MENU] key to
close all menus.
MENU
H-SCAN SETTING
OTHERS
COLOR
: COLOR 1
COLOR SETTING...
COLOR RESPONSE : COLOR CURVE 3
COLOR RESPONSE...
GAIN OFFSET
: 0
SIGNAL LEVEL
: 0
FAR TVG CURVE
: TVG2
ABSORPTION COEFF : 23.5dB
TVG DISTANCE...
2ND AGC DISTANCE : 0m
NEAR AGC DISTANCE: 200m
SMOOTH ECHO RNG : 0
SMOOTH ECHO CIR : 0
GAIN CONTROL
: NORMAL
BEAMWIDTH...
.OTHERS menu
MENU
H-SCAN SETTING
OTHERS
BEAMWIDTH
BEAMWIDTH A : 0
BEAMWIDTH B : 0
2. HORIZONTAL MODE
QUIT
QUIT
QUIT
QUIT
QUIT
QUIT
QUIT
2-25