Furuno FAR-2167DS-BB Installation Manual page 70

1. Remove the top cover and open the upper part of the processor unit.
2. Fix the RGB-BUFF board (03P9229B board) with four screws. (See the figure below.)
3. Attach the connector assemblies to J1 and J3 on the 03P9229B board as follows.
J1: 13-pin connector of the connector assembly 03-2094
J3: 3-pin connector of the connector assembly 03-2093
4. Attach six sets of spring washers and spacers at the locations shown below.
Spring washer, spacer
03P9342 board
J615 (Connect connector assembies at step 8.)
4-14
Processor unit, side view
03P9229B board
J3
J1 J2
Processor unit (bottom chassis)
DVI-D port
(Connect DVI cable at step 12.)
J2 (Connect RGB Cable at step 10.)