Furuno FAR-2167DS-BB Installation Manual page 28

7. Using the terminal opener provided, connect cores (except coaxial cable) to their appropriate
locations on TB801 on the TB Board. Refer to the interconnection diagram for wiring details.
8. Connect the coaxial cable to TB802, referring to the right-hand illustration below..
Wiring WAGO connector
Wire
Twist
Procedure
1. Twist core.
2. Insert terminal opener as shown and
push down.
3. Insert core into hole.
4. Release terminal opener.
5. Pull wire to confirm that it is firmly in
place.
9. Attach crimp-on lug (FV5.5-4) to the shield of the signal cable and fasten it with the screw at
the location specified in the illustration on the preceding page.
10.Process unused cores as follows:
a) Slip shrink tubing onto cores and heat.
b) Bind unused cores with cable tie.
11.Unfasten the gland nut for the HV cable and remove gasket, flat washers (3 pcs.) and gland
cap. (The gland cap may be discarded.)
12.Fabricate the HV cable as shown below.
Vinyl
sheath
2-4
Push down.
Terminal opener
WAGO connector
How to wire WAGO connector
20 mm
5 mm
Sheath
L
Armor
L: 300 mm (red)
L: 370 mm (black, white)
How to fabricate HV cable TYPCY-1.5
Fastening coaxial cable
Taping
Fasten conductor with screw.
NOTICE
Fasten BARE conductor. Do not use
crimp-on lug, to prevent increased
contact resistance.
6
SECTIONAL VIEW
Fasten shield
by clamp.
Armor
Sheath
Conductor
2
S = 1.50 mm
= 1.56 mm