Furuno FAR-2167DS-BB Installation Manual page 33

Connection of cables
The power cable is connected to the terminal board on the rear panel and the signal cable from
the monitor unit is connected to the DVI-D connector. Other cables are connected to the printed
circuit board 03P9342. Be sure to ground the unit, with IV-8sq wire (local supply).
Power cable
Cable clamp
GND TERMINAL
*: The connector with EMI core should be connected to the processor unit.
**: The configuration of optional cable between the processor unit and the control unit is as follows.
Note that the cable fabrication for each end is different.
Control unit
150 mm
When the RCU-016 is installed, optional cable (XH10P-W-5P-A, L=10/20/30M) is required. Cable
fabrication for each end is the same.
Control unit
150 mm
Monitor unit
*
Network DVI-D monitor
Antenna unit
Processor unit, rear view
10/20 * /30 * m
Cable XH10P-W-6P L=20/30M
10/20/30 m
Cable clamp for power cable
Terminal board for power cable
1
15
DC/AC
2
21 2 3 4 5 6 18
17
9 14
HDG RSD
9
ACK
18.9
24
8 28
1 7
VDR IN
GYRO PSU004
AIS AD100
VDR IN
Power supply unit
Gyrocompass
AD-100
AIS
Remove the
protective cover.
F70
FUSE
F1
Control unit
Heading senor
Speed log
Navigator
19 20
24' 26
7.4 7
VDR OUT
Memory Card IF unit
VDR OUT
Processor unit
300 mm
*: Option
Processor unit
150 mm
**
2-9