Furuno FAR-2167DS-BB Installation Manual page 60

7. Pass the gyrocompass cable through the cable clamp and connect it to connector J602 as
shown in the figure below.
8. Attach the clamps to the plastic cover and then attach the cover to the GYRO CONVERTER
board as shown in the figure below. Pass cables thru the clamp ED-1.
Clamp EDS-1
Insert cables to these
clamp.
9. Close the processor unit.
4-4
Plastic cover
Attaching plastic cover for GYRO CONVERTER board
Screw
M4X8 3 pcs
Clamp CKS-10-L
Clamp CKS-13-L