Furuno FAR-2167DS-BB Installation Manual page 30

4. In the order shown in the figure below, pass the gland nut, flat washers (3 pcs.) and gasket onto
the power cable.
5. As shown in the figure below, fold back armor onto flat washer and insert it thru the other flat
washer. Cut off part of armor that protrudes past flat washer..
6. Pass the power cable though its cable gland and then tighten the gland nut..
7. Pass the power cable to the rear of the antenna unit.
Terminal for power cable
8. Connect the power cable to its terminal, referring to the interconnection diagram.
9. Close the cover.
10.Seal the cable gland for the power cable with putty.
2-6
Flat washer
(1) (2) (3)
Power cable
Cut off armor that
Gland nut
protrudes past washer.
Gasket
Passing flat washer, etc. onto HV cable
Antenna unit, left-side view
Cable gland for power cable
(TPYCY-2.5)