Furuno FAR-2167DS-BB Installation Manual page 11

Assembling the antenna unit
The antenna unit should be assembled before mounting it. Follow the procedure below to
assemble the antenna unit.
1. Screw the guide pins (2 pcs.) in the radiator.
2. Remove the protective cap from the choke guide and radiator.
3. Grease the O-ring and set it to the groove on the choke guide.
4. Place the radiator on the radiator bracket. (Radiator direction is shown by the logo on the
bracket. If reversely oriented the radiator cannot be set to the bracket.)
5. Loosely fix the radiator to the radiator bracket with hex bolts (M10×25), spring washers and flat
washers.
6. Remove the guide pins and tighten the hex bolts.
Spring washer,
flat washer,
10 pcs. each,
M10x25
Protective cap
Radiator bracket
Choke guide
O-ring
Antenna radiator
CAUTION
Be sure to remove the guide pins
after fixing the radiator.
Injury may result if the guide pins loosen
and fall from antenna radar platform.
Assembling the antenna unit
Do not remove teflon tube
from the center conductor.
Radiator front
Guide pin (2 pcs.)
Arrow mark for the radiator front.
1-3