1.
Remove the top cover and open the upper part of the processor unit.
2. Fix the 03P9229B board (RGB-BUFF) with four screws. (See the figure below.)
3. Attach the connector assemblies to J1 and J3 on the 03P9229B board as follows.
J1 13-pin connector of the connector assembly 03-2094
J3 3-pin connector of the connector assembly 03-2093
4. Attach six sets of spring washers and spacers to the positions shown below.
Spring washer, spacer
03P9342 board
J615 (Connect connector assemblies at step 9.)
5. Attach the DVI-RGB conversion board to the location shown in the figure on the next
page.
Processor unit
03P9229B board
J3
J1
J2
Processor unit (Lower part)
4. INSTALLING OPTIONAL EQUIPMENT
DVI-D port
(Connect DVI cable at step 13)
J2 (Connect RGB Cable at step 11.)
4-13