Furuno FAR-2117 Installation Manual page 29

11. Set the transceiver module to the antenna unit, push it in until it stops, and then tighten
fixing bolts (4 pcs.). Connect plugs P823, P803, P831, P921 and J911 (if installed).
Fasten the shield wire to the wing nut on the transceiver module.
Connector
plug
Cable clamp for
antenna cable
12. Confirm that all screws are tightened and all wiring is properly made. Confirm that
waterproofing gasket, bolts and tapping holes of antenna unit are coated with silicone
grease. Close the antenna unit cover (torque: 2.5 N·m).
CAUTION
Push in transceiver unit until it stops.
Failure to do so may cause leakage of
microwaves.
03P9349
Bow mark
Antenna unit, front view
Clamp for
coaxial cable
Connect coaxial cable here.
Transceiver module
Signal cable
Connect shield wire to with wing
nut at the opposite side of the
transceiver module.
2. WIRING
2-5