Furuno FAR-2117 Installation Manual page 70

4. INSTALLING OPTIONAL EQUIPMENT
Desktop mount
For desktop mount, the optional desktop mount kit FP03-10201 is required. Refer to the end
of this manual.
1. Fix the mounting bracket 19-023-3081 on the unit with four screws.
2. Mount the above assembly on a desktop with four tapping screws.
Console mount
For console mount, the optional console mount kit FP03-10202 is required. Refer to the end
of this manual.
1. Fix the mounting bracket 19-023-3091 on the unit with four screws.
2. Mount the above assembly to the console with four sets of nut, spring washer and flat
washer.
Connection
1) Connection between one processor unit and one memory card IF unit
Connect as shown in the figure below.
Processor unit
J614
NETWORK
2) Connection between one memory card IF unit and multiple processor units
Prepare optional LAN cable kit and switching hub HUB-100. Connect as shown in the next
page. Set the radar number on the INSTALLATION menu (see page 3-10), and then turn the
power off and on.
Type
OP03-28900
OP03-28910
OP03-28920
4-10
12 VDC
MJ-A3SPF0015-100 (10 m)
PSE-4PTX-BL (10 m)
LAN cable kit
Code No.
000-082-658 Cable FR-FTPC-CY (10 m), Modular connector 2 pcs.
000-082-689 Cable FR-FTPC-CY (20 m), Modular connector 2 pcs.
000-082-660 Cable FR-FTPC-CY (30 m), Modular connector 2 pcs.
Memory card IF unit
12 VDC
NETWORK
RJ-45
Contents
two mini-cards