Furuno FAR-2117 Installation Manual page 74

4. INSTALLING OPTIONAL EQUIPMENT
J4
6. Attach the 10-pin connector from J1 on the 03P9229B board to J9 on the DVI-RGB
board.
7. Attach the connector assembly 03-2092 to J4 on the DVI-RGB conversion board.
8. Remove connector housing J615 from the 03P9342 board. Connect the cable from J3
on the 03P9229B board and the cable from J4 on the DVI-RGB conversion board to
J615. After connection, attach J615 to the 03P9342 board.
To connect wires to the connector housing, use the terminal opener (supplied as installation
materials) as shown below.
9. Connect the DVI cable to J3 on the DVI-RGB conversion board. Connect the end which
does not have the ferrite core.
10. Pass an RGB cable (local supply) through the cable clamp and connect it to J2 on the
03P9229B board.
11. Pass the DVI cable through the cable clamp, laying the section with copper tape in the
cable clamp.
12. Assemble the processor unit and connect the other end of the DVI cable to DVI-D port.
4-14
DVI-RGB
Conversion board
J9
Fixing the DVI-RGB conversion board
J615 Housing
2
3
4
5
Insert core
2
Connecting wires to the housing
J3 (Connect DVI cable at step 10.)
Terminal opener
Press downward
1