Pro Vision BODYCAM 4 User Manual page 27

CARE AND MAINTENANCE
5. Disconnect the original battery by gently pulling on the red/black wires in the upper left corner of
the camera to disconnect the white connector from its jack.
6. Connect the new battery to the white connector in the upper left of the camera, ensure the red
wire is oriented towards the top as designated.
Important! Use only plastic, wood, or other non-metal tools to assist in reconnecting the
connector; metal tools could short the pins and cause damage to the battery.
7. Place the new battery in the camera with the label facing outward and the wires exiting the upper
right corner of the battery. The wires should fold under the top edge of the battery as shown in the
photo below.
8. Flip over the back cover and inspect the gasket. It should be seated in the channel completely as
shown below. If the gasket is not seated, gently reseat it in the channel using a paperclip taking
care not to damage the gasket.
BAD
9. Place the battery cover back onto the camera and recheck to ensure the gasket did not shift.
10. Reinstall the 6 screws. Start with the center screws and then the outer screws. Proper screw
torque of 3 in-lbs. is needed to ensure the gasket seals properly so the camera can remain water-
tight.
11. Dispose of the old battery. Check your local regulations and dispose accordingly.
GOOD
24
PRO-VISION
®
BODYCAM 4 USER GUIDE
provisionusa.com