Pro Vision BODYCAM 4 User Manual page 10

SETUP
Multi-Dock Mounting
The multi-dock is commonly placed on the desktop or flat shelf; its weight and
rubber feet will hold it in place during docking and undocking.
The multi-dock has screw slots on the bottom for attaching to a surface or wall
mounting. The slots are spaced 6" (15 cm) apart left to right and spaced 10.25"
(26 cm) apart front to rear. If mounting the dock vertically, orient it with the
cables exiting the top so the camera's top display is orientated correctly when
docked.
Multi-Dock Connections
The multi-dock can be used for charging only, or for both charging and video
offload. For charging-only applications, only the power cable needs to be used
and the Ethernet ports can be left disconnected.
Power: Connect the included power cable to the power port on the rear of the
dock and connect the opposite end to a standard power outlet.
Network: Connect the included Ethernet cable to one of the LAN ports on the rear of the dock and the
opposite end into an active Internet port on your network. There are two Ethernet ports on the
rear of the dock; both ports are LAN ports and function the same. After connecting one port to
an active Internet connection, the second port can be used as a pass-through to continue to
another docking station (single or multi), to a PC, or to another network device. This allows
multiple docking stations to be connected to a single available Internet port on the network. It is
important to note that continued chaining of devices will reduce the overall upload speed of the
docks because all the data is passing through the first Ethernet cable. For maximum speed,
connect each dock directly to a Gigabit Ethernet port on your network.
7
PRO-VISION
BODYCAM 4 USER GUIDE
Power
Ethernet
provisionusa.com
®