User Login/Logout - Pro Vision BODYCAM 4 User Manual

RFID USER LOGIN

User Login/Logout

After devices are registered and user assignment is complete, the cameras are ready for use.
Login
Remove the camera from the docking station; the camera will not be able to be used until it is
logged in. Hold the camera's front Event button near the RFID tag and press the "F2" button on
the side of the camera to begin RFID scanning. The display will show "SUCCESS" then show
"READY" with the logged-in user's name below. Once the display shows "READY" on the
screen it can now be used; it may take a few seconds to log the user in and apply the settings.
Note: If the scan does not detect the RFID tag, the camera will display "RETRY" on the display and "F2"
can be pressed again to retry the scan.
Logout
The default configuration requires the camera to be logged out manually before another
user is logged in. To log out a user, press and hold the "F2" button on the side of the
camera for 3 seconds while it is docked. The camera will vibrate, and the display will
show "NOT READY" / "NO USER LOGGED IN" when the camera is logged out. The
camera can then be undocked and logged in following the procedure above.
There is an option in the BODYCAM 4 configuration that will allow the camera to automatically log out.
1. To enable the automatic log out option in SecuraMax, go to the "Admin" menu, choose "Lookups"
and select "BODYCAM 4 Configs".
2. Select the desired camera configuration profile and choose "Edit".
3. Locate the "Automatic User Logout" option and then choose the desired behavior.
4. Save the configuration after the new setting is chosen.
21
PRO-VISION
®
BODYCAM 4 USER GUIDE
provisionusa.com