Camera Mounting; Rotating Garment Clip; Heavy Duty Magnet Mount - Pro Vision BODYCAM 4 User Manual

CAMERA MOUNTING

Camera Mounting
The BODYCAM 4 has multiple mounting options available for purchase; all mounts attach to the rear of
the camera on the sliding rail.

Rotating Garment Clip

The rotating garment clip (P/N: BC4-MNT-GAR) is a simple mounting method that
attaches to a garment with a spring-loaded plastic clip. The clip can rotate 360° to
allow it to attach to the garment at different angles. The inner portion of the clip has
interlocking teeth to provide grip onto the attachment point of the garment.
Mounting:
To install the mount onto the camera, simply slide the mount upward into the slot on the
rear of the camera until it clicks into place. The mount can be left attached to the camera in
the docking station.
Removal:
To remove the mount, rotate the clip so it is perpendicular to the camera body; this
provides access to the retention tab. Hold the camera with one hand and the clip with the
other. Push the retention tab on the clip away from the camera body while simultaneously
sliding the clip down and out of the camera slot.
Heavy-Duty Magnet Mount
The magnet mount (P/N: BC4-MNT-MAG) consists of two parts: the inner mount,
and the outer mount. The inner mount is placed behind the garment and the outer
mount is placed on the outside of garment holding the mount in place with strong
magnets.
Mounting:
1. Slide the camera down onto the outer mount until it clicks in
place.
2. Place the inner mount behind the garment in the desired
mounting area.
3. Hold camera with attached outer mount over the garment in
front of the inner mount and they will attach magnetically.
Removal:
1. Firmly grasp the side rails of the outer mount and tip assembly right
or left to separate the mount, then pull the outer mount away to
remove.
2. Remove the inner mount from behind the garment.
Storage:
It is best to store the mounts with only two of the magnets on each portion connected
for easy separation.
Safety Information:
Individuals with pacemakers or internal medical devices should use caution when handling the
BODYCAM 4 magnetic mount. Magnetic fields may affect the operation of these devices. Consult with
your physician and the manufacturer of your medical device to determine its susceptibility to static
magnetic fields before handling the magnetic mount. Individuals with pacemakers and other internal
medical devices that could potentially be affected by static magnetic fields should not wear the magnetic
mount.
The BODYCAM 4 Magnetic Mount contains strong magnets and can pose a pinch-point hazard. Exercise
caution when separating and connecting the outer and inner magnetic mount. When connecting the two
pieces, ensure that all body parts are clear as the magnets will snap together.
10
PRO-VISION
®
BODYCAM 4 USER GUIDE
provisionusa.com