Screw-To-Fit Mount; Screw-On Mount - Pro Vision BODYCAM 4 User Manual

CAMERA MOUNTING
PRO-VISION
®
BODYCAM 4 USER GUIDE

Screw-to-fit Mount

The screw-to-fit mount (P/N: BC4-MNT-STF) is a durable mount that is intended for use
in applications where a garment is too thick for a magnet mount, and/or does not have
provisions for attaching a clip. Typically, this mount is used in applications where heavy
coats or outer vests are worn. The mount is semi-permanently attached to the garment
using a backing plate and screws. The mount is machine washable so it can stay
attached to the clothing indefinitely. Using this mount will leave 4 small holes in the
garment and may deform the shape of the garment surface over time. The mount
consists of an adapter that mounts to the rear of the camera and the mounting portion
that is attached to the garment's epaulette. The mount can be left attached to the vest or
jacket while the camera is removed for charging and upload. To attach the camera, slide it down into the
mount until it clicks. To remove the camera, rotate it 180° and slide upward to remove as shown below at
right.

Screw-on Mount

The screw-on mount (P/N: BC4-MNT-SCO) is intended to be used in applications where
the camera will be mounted to a fixed bracket, wall, or other non-user mounted
application. Attach the mount to the surface using four (4) suitable mounting screws for
the desired surface. Attach the mount to the rear of the camera as shown below left. To
attach the camera, slide it down into the mount until it clicks. To remove the camera,
rotate it 180° and slide upward to remove as shown below at right.
12 provisionusa.com