LeCroy WaveSurfer 400 Series Service Manual page 67

Calculate the ratio to 10 MHz for each channel, pk-pk
45X) pk-pk
,
WaveSurfer 42X) and compare the results to the limits in the test record.
Repeat the above steps for V/div setting of 50 mV, 100 mV, and 500 mV, using
the appropriate Bandwidth - CHx vvmv.lss (where x is channel and yy is V/div
setting) panel setup and recording your results in Tables 10 through 12. Use the
power setting and attenuators as shown in the tables.
Rev. D Sept 2007
/pk-pk (for WaveSurfer 43X)
350.1 10
/pk-pk
500.1 10
pk-pk /pk-pk
, or 200.1 10
Performance Verification 5-27
(for WaveSurfer
(for