Related Manuals for Teknik 5426463
Summary of Contents for Teknik 5426463
- Page 1 Teknik You could totally write a novel on this. Metro Desk NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. Model 5426463 PLEASE READ AND KEEP FOR FUTURE REFERENCE.
- Page 2 Table of Contents Assembly Tools Required Hardware Identifi cation No. 2 Phillips Screwdriver Part Identifi cation Tip Shown Actual Size Assembly Steps Français 10-11 Español 12-13 Skip the power trip. This time. Safety Warranty Hardware Identifi cation å Screws are shown actual size. You may receive extra hardware with your unit. GLASS SPACER CARD - 1 NUT - 4 L-WRENCH - 1...
- Page 3 Now you know Part Identifi cation our ABCs. å While not all parts are labeled, some of the parts will have a label or an inked letter on the edge to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts. LEFT END (1) RIGHT END (1) FRAME (2)
- Page 4 Step 1 Assemble your unit on a carpeted fl oor or on the empty å carton to avoid scratching your unit or the fl oor. Fasten the BRACES (D) to one of the FRAMES (C). å Tighten four 1/2" HEX HEAD SCREWS (7) using the L-WRENCH (3).
- Page 5 Step 2 Fasten the remaining FRAME (C) to the BRACES (D). å Tighten four 1/2" HEX HEAD SCREWS (7) using the L-WRENCH (3). 1/2" HEX HEAD SCREW (4 used in this step) Page 5...
- Page 6 Step 3 Fasten the SHELF (G) to the FRAMES (C). Use six 1/2" å PAN HEAD SCREWS (6). NOTE: You should start each SCREW a few turns before å completely tightening any of them. 1/2" PAN HEAD SCREW (6 used in this step) Page 6...
- Page 7 Step 4 Fasten the ENDS (A and B) to the SHELF (G). Tighten six å 1/2" HEX HEAD SCREWS (7) using the L-WRENCH (3). NOTE: You should start each SCREW a few turns before å completely tightening any of them. 1/2"...
- Page 8 Step 5 Fasten the BACK BRACE (E) to the ENDS (A and B). å Tighten four 1" MACHINE SCREWS (5) and four NUTS (1) using the WRENCH (4) and a screwdriver. (4 used) 1" MACHINE SCREW (4 used in this step) Page 8...
- Page 9 Step 6 Carefully stand your unit upright. å Peel a GLASS SPACER (2) from the GLASS SPACER CARD (2) and stick them onto the tabs of the FRAMES (C). å Place the GLASS TOP (F) with the shiny surface facing up onto the GLASS SPACERS. å...
- Page 10 WARNING Please use your furniture correctly and safely. Improper use can cause safety hazards, or damage to your furniture or household items. Carefully read the following chart. Look out for: What can happen: How to avoid the problem: • Overloaded shelves. •...