Wheel Replacement - MG Gloster Manual

Spare wheel storage
1 Place the wheel on the ground with the air valve facing up (be careful
not to place it reversely).
2 Place the wheel at the rear bottom of the vehicle.
3 Place the spare wheel tray in the rim center, and then adjust the tray
to a proper position to allow it to be tightly connected with the
spare wheel.
4 Rotate the wheel nut wrench clockwise until a click is heard, and the
spare wheel is loaded in place.
After placing the wheel on the spare wheel holder, check whether
the wheel mounting is tight. If the wheel is loose, it may fall off
owing to vibration and cause an accident.
5 Screw the spare wheel rotary cap, and close the luggage
compartment rear lid.
EMERGENCY TROUBLESHOOTING

Wheel replacement

Vehicle parking
Please choose a solid and flat place to park the vehicle,
where will neither hinder the traffic, nor throw you into
a traffic accident. If your vehicle is parked on a public
road, please turn on the hazard warning lamp and place
a warning triangle.
Make sure that the ground where the jack is located is
solid enough to support the jack and the vehicle to be
lifted, or the jack may become unstable and move, thus
damaging the vehicle and/or causing personal injury.
Please use appropriate wheel wedges to hold other
wheels.
If your vehicle is parked on a slippery place, please do
not use the jack. If the conditions are not suitable for use
of the jack, or you are lack of confidence to complete the
task in a safe manner, please call for help. Make sure the
front wheels point straight ahead.
When the engine is turned off, pull up the parking brake
handle, if your vehicle is equipped with electronic
parking brake system, pull up the electronic parking
brake (EPB) switch to activate the electronic parking
187