Chassis Technical Parameters - MG Gloster Manual

Chassis Technical Parameters:

Item
Front Suspension Structure
Rear Suspension Structure
Dynamic Balance Requirements of
Steel Wheels
Dynamic Balance Requirements of
Aluminum Wheels
Rational Range of Brake Pedal Free
Stroke
Rational Use Range of Brake Friction
GENERAL TECHNICAL PARAMETERS
Double wishbone independent suspension
Five-link non-independent suspension
Residual dynamic unbalance allowable at one side: below 10 grams
Maximum balance block applied at outer side is 60 grams, and the total of two sides shall not
Residual dynamic unbalance allowable at one side: below 8 grams
Maximum balance block applied at one side is 80 grams, and the total of two sides shall not
Friction material thickness is greater than 2 mm
Parameters
exceed 120 grams
exceed 160 grams
within 10 mm
229