Extension/Retraction Of Mechanical Key Portion; Replace Battery In Remote Key - MG Gloster Manual

Extension/Retraction of Mechanical Key Portion

Mechanical Key Portion of Remote Key can be extended or retracted,
hereinafter referred to as mechanical key portion.
Mechanical Key Portion of a Remote Key with PEPS
Press the release button on the remote key with PEPS, remove the rear
trim panel and pull the mechanical key portion from the ey body.
To retract the mechanical key portion, directly insert it into the ody of
remote key with PEPS and close the rear trim panel.
BEFORE YOU DRIVE

Replace Battery in Remote Key

Key battery has the risks of fire, explosion and
combustion. Do not charge the battery. The used
battery shall be disposed In a proper way. Keep the
battery in the place out of reach by children.
To replace the battery, operate as per the following steps:
k
Remote key with PEPS battery replacement
b
1 Release the button on the remote key with PEPS.
2 Remove the key head from the key itself.
3 Pry the upper and lower panels of the main body, remove the PCB
(with battery) from the lower panel.
Never use a metal tool to pry the PCB.
4 Withdraw the old battery and fit the new battery. (Same
specification)
It is essential that the correct battery polarization is observed.
5 Put the plastic support with battery into the lower panel of the main
body, and install the PCB subsequently.
6 Refit the upper and lower panels of the main body.
Caution
Caution
9