Key To Lubrication Diagram - MG Midget Mark II Driver's Handbook Manual

KEY TO LUBRICATION DIAGRAM LUBRICATION DIAGRAM
NOTE.-The engine oil change periods are those recommended when a multigrade oil is
used. Monograde or single viscosity oil should be changed at 3,000 mile intervals.
DAILY
(1) ENGINE. Insp ect the oil level, and
top up if necessary with oil to
Ref. A .
EVERY 3,000 MILES (5000 Km.)
(2) STEERING TIE-ROD BALL
JOINTS (2 nipples). Give three or
four strokes of a gun filled with
grease to Ref. C.
(3) SWIVEL AXLES AND SUS-
PENSION LOWER JOINTS (6
nipples). Give three or four strokes
of a gun filled with grease to
Ref. C.
(4) PROPELLER SHAFT (2 nipples).
Give three or four str okes of a gun
filled with grease to Ref. C.
(5) HAND BRAKE CABLE (1 nip-
pie). Give three or four strokes of
a gun filled with grease to Ref. C.
(6) HAND BRAKE COMPEN-
SATOR LEVER (1 nipple). Give
three or four strokes of a gun filled
with grease to Ref. C.
(7) CARBURETTERS. Top up dam-
per assembl y reservoirs with oil to
Re
EVERY 6,000 MILES (10000 Km.)
(8)
ENGINE. Drain off the old oil
an d refill with fresh oil to Ref. A.
(9)
GE ARBOX. Top up if necessary
to the filler plug level with oil to
Ref. A.
( 10)
R EAR AXLE. Top up if necessary
to the filler plug level with oil to
Ref. B.
(11) DISTRIBUTOR. Lubricate all
parts as necessary.
( 12)
OI L FILTE R. Wash the bowl in
fuel and fit a new element.
(13) DYNAMO. Add a few drops of
oil to Ref. A through the oil hole
in the commutator end bearing.
EVERY 12,000
MILES (20000
Km.)
(14) STEERING-RACK. Apply the
grease gun filled with oil to Ref. B
to the nipple on the steer ing rack
and give 10 strokes only.
(15) WATER PUMP. Remove the plug
and add grease to Ref. C ; replace
the plug .
NOTE.-Oil and grease references are
to be found on page 68.