Table of Contents
Advertisement
Carefree of Colorado
S
D
ETTING THE
EFLECTOR
Optional Shim
1. Position the deflector brackets on the room face using
2. Attach the brackets.
•
Using a quality silicone sealant, coat the mounting surface of the bracket with particular attention
around the mounting holes.
•
Position the bracket and optional shim (if used) and attach using five
(5) #12 x 1 self-drilling screws.
3. Snap the bracket cover on to the bracket to cover the screw heads. The tab on
the back of the cover goes into the slotted hole of the bracket.
NOTE: If it is necessary to remove the cover after installation, slide
a small pin (e.g. paper clip) in the end under the cover. Lift
the locking tab and gently pull out the end of the cover.
Repeat for other side of the cover.
M
D
OUNTING THE
1. Lift the deflector assembly up and onto the mounting brackets. The deflector hooks into the brackets.
2. Horizontally center the assembly over the room.
3. In the screw groove formed between the bracket and deflector, drill a 1/8" pilot hole through the bottom
of the bracket in the screw groove. Secure the assembly to the bracket using four (2 per bracket) #10 x
1 self drilling screws. If the deflector moves during drilling, complete the drilling operation then realign
the defector in the brackets.
M
OUNTING
Bracket Cover
#12 x 1 Self Drilling Screw
Figure 7. Setting the Deflector Brackets.
A
EFLECTOR
SSEMBLY
Self-Drilling Screw
Mounting
Bracket (ref)
Deflector Assy
Figure 9. Mounting the Deflector Assembly.
B
RACKETS
1" min
12" max
A as shown in Figure 7.
BASELINE
#10 x 1
(qty: 4)
Screw (ref)
Pilot Hole
5
Do Not Use Slot for
Mounting Screws
Baseline "A"
Deflector Assy
Mounting Bracket
Locking
Pin
Figure 8. Removing the
Cover.
#10 x 1
O 1/8"
Deflector
Assy (ref)
052520-001r17
Table of Contents
S
UMMIT
SOK3016b
Tab
SOK3013
SOK3009
Advertisement
Table of Contents
