Mounting The Deflector Assembly - Carefree SUMMIT Installation Manual

Table of Contents

Advertisement

Carefree of Colorado
M
D
OUNTING THE
The deflector is shipped in two sections. The RH section has the RH end cap and the center splice
assembly. The LH section has the LH end cap only.
Pins
Deflector Profile
4.
Lift the RH deflector assembly up and onto the mounting brackets. The deflector hooks into the
brackets.
5.
Horizontally align the center splice assembly with the centerline of the room. This should coincide
with the center line of the center mounting bracket.
6.
In the screw groove formed between the RH bracket and deflector, drill a 1/8" pilot hole through the
bottom of the bracket in the screw groove. Secure the assembly to the bracket using two (2) #10 x 1
self drilling screws. If the deflector moves during drilling, complete the drilling operation then realign
the deflector. Do not attach the deflector to the center bracket at this time.
7.
From the splice assembly, remove the cotter pin and the center cover mount. Set both components
aside to reinstall later.
NOTE: The cover mount is not installed if the optional cover is not to be installed.
8.
Lift the LH section of the deflector up and onto the brackets.
9.
Align the LH section with the RH section and press the LH section onto the split pins of the splice
assembly.
Tip: The split pins are a tension fit. If necessary, remove the LH end cap and set aside. Use a rubber
mallet and tap the LH section onto the pins. Use care to not bend or distort the deflector. When the
inner end is tight against the splice assembly, reattach the end cap.
10. For the left and center brackets: In the screw groove formed between the bracket and deflector, drill a
1/8" pilot hole through the bottom of the bracket in the screw groove. Secure the assembly to the
brackets using four (2 per bracket) #10 x 1 self drilling screws.
A
EFLECTOR
SSEMBLY
Splice
Assy
Remove
Cotter Pin
A
Detail
Deflector Assy
Figure 21. Mounting the Deflector Assembly.
#10 x 1
Self-Drilling Screw
A
Screw (ref)
Center
Cover Mount
Pilot Hole
14
(qty: 6)
#10 x 1
O 1/8"
Deflector
Assy (ref)
052520-001r17
Table of Contents
S
UMMIT
SOK3038

Advertisement

Table of Contents
loading

This manual is also suitable for:

Summit xl

Table of Contents