Table of Contents
Advertisement
Carefree of Colorado
M
L
OUNTING THE
IFT
Mounting Pad
Lift Bar Assy
A
(Refer to Figure 12)
1.
It is necessary to set the extension arm length for the correct room extension length. The extension arms
consist of an inner and outer channel. Slide the outer channel to the correct dimension using the scale
marks on the inner channel. Use one (1) #7 x 7/16 self-tapping screw to secure the channels. Repeat for
the other three arms.
2.
Set the lift bar assembly onto the support brackets and deflector assembly. Center the mounting pads of the
arms on the brackets.
3.
In the screw grooves of the wall brackets attach the arms using 6 (3 per arm)
#10 x 3/4 thread type A screws. Torque screws to 15 in-lbs.
4.
Examine the deflector extrusion and determine if the deflector is style 1 or style 2 (see sample above).
•
For style 1: In the screw groove of the deflector, attach the arms using 6 (3 per arm) #10 x 3/4
thread type A screws. Torque screws to 15 in-lbs.
•
For style 2: Position the arm mounting pads on the positioning groove of the deflector and attach
using 6 (3 per arm) #10 x1 self drilling screws.
5.
Center the top rail of the lift bar assembly. Tighten the two
These should be placed next to the inner face of the carriers but with adequate clearance for a socket
or closed end wrench to fit over the bolt head.
6.
Extend the room out completely.
7.
Repeat step 5 for the
B
A
AR
SSEMBLY
Outer Channel
#7 x 7/16 Screw
Align Edge with
Extension Scale
A
DETAIL
Figure 12. Mounting the Lift Bar Assembly.
stop bolts. These are placed next to the outer face of the carriers.
OUTER
Carrier
Stop Bolt
(qty: 4)
#10 x 3/4
Thread Type A Screw
(qty: 6)
Mounting
Bracket (ref)
stop bolts, torque to 34 in-lbs..
INNER
8
S
UMMIT
Threaded
Screw Groove
Style 1
Positioning
Groove
Style 2
Lift Bar Assy
(ref)
#10 Screw
(ref)
Refer to Text
Deflector
Assy (ref)
SOK3010
052520-001r17
Table of Contents
Advertisement
Table of Contents
