Table of Contents
Advertisement
Carefree of Colorado
Cover Bumpers
The Summit cover is shipped with bumpers to prevent rattling. Quantities are three (3) for units under 14'
and five (5) for units 14' and longer.
To replace missing or damaged bumpers:
3. In the positions shown, fully press the first round section into the inner slot. This is the same slot that
the latch springs are mounted in. Please note the orientation of the bumper.
Tip: Press one end of the bumper into the slot. While holding the bumper in place, gently stretch the
bumper. This will temporarily make the diameter smaller and easier to press into the slot.
4. Stretch the bumper around and press the second round section into the outer slot.
Outer Slot
Inner Slot
Bumper
I
'
N
: W
NSTALLER
S
OTE
MANUAL AND PLACE WITH THE COACH OWNER INFORMATION
Intermediate Bumpers Used On
14' Lengths and Longer
(Cover Shown in Raised Position)
HEN COMPLETED WITH THE INSTALLATION
0" - 3/4"
,
CUT OFF THE LAST SHEET OF THIS
.
19
S
UMMIT
1/4 Deflector Length
(typ)
4"
(typ)
SOK3039a
052520-001r17
Table of Contents
Advertisement
Table of Contents
