Table of Contents
Advertisement
Carefree of Colorado
A
F
TTACHING THE
Cover Retaining Screw
(4 plcs)
1.
If removed, thread the 1/4-20 x 1 1/2 socket head screws into the end caps. On one side thread the
screws until flush with the inside of the end cap. On the other side, thread the screws until they
project out of the end cap approximately 1/2".
NOTE: The bottom screw holes are threaded at the factory. It will be necessary to force-
thread the top holes in the end cap using the supplied screws.
2.
Lift the cover up and place one end over the screws that project out of the end cap. The screws fit
into the slots of the cover.
3.
Align the cover with the other end cap and thread in all the attach screws thru the end caps and into
the cover. Hand tighten only.
4.
For covers 12 feet and longer: Locate the latch lever at the center of the cover. Using a screw driver
or similar tool, push the lever to the left and hold; press the cover into position then release the latch
lever. The latching pin is spring loaded and will slide into the locking channel.
Cover Bumpers
The Summit cover is shipped with bumpers to prevent rattling. Quantities are two (2) for units under 10";
three (3) for units 10' to 12' and five (5) for units 12' and longer.
Outer Slot
Inner Slot
Bumper
To replace missing or damaged bumpers:
1. In the positions shown, fully press the first round section into the inner slot. This is the same slot that
the cover retaining screws are mounted in. Please note the orientation of the bumper.
Tip: Press one end of the bumper into the slot. While holding the bumper in place, gently stretch the
bumper. This will temporarily make the diameter smaller and easier to press into the slot.
2. Stretch the bumper around and press the second round section into the outer slot.
C
RONT
OVER
Thread Screw In Until
1/2" Projects Out of Cap
(one side only)
A
Figure 15. Attaching the Front Cover.
Covers 12' and Longer with Center Latch
Center Bumper Used On
10' - 14' Lengths Only
Figure 16. Cover Bumpers.
0" - 3/4"
Covers Under 12'
(Cover Shown in Raised Position)
10
Latch Lever
Center Latch Pin
12' or Longer Covers Only
A
Detail
1/4 Deflector Length
(typ)
(typ)
(typ)
052520-001r17
Table of Contents
S
UMMIT
SOK3046
4"
4"
SOK3039
Advertisement
Table of Contents
