Carefree SUMMIT Installation Manual page 19

Carefree of Colorado
I R
NSTALLING THE
NOTE: Because of the length and weight of the rollbar and fabric, it will be necessary to have 3 people to
install the rollbar; one person at each end, with the third person to support the center.
3/16 Pop Rivet
(qty: 4)
Fabric
Left Side
Black
Polycord (With Threaded Insert)
A
Detail
#6 x 3/8 Screw
Thru Polyrod Into
Roll Bar (2 plcs)
C
Detail
10. Close the room if open.
11. (Detail A) Slide the rail adaptor (2 pieces) into the awning rail. Note the orientation as shown.
12. (Detail B) Slide the two roll bar halves together. The splice is a tension fit. It may be necessary to tap one
end of the roll bar to press the two halves together. Align the predrilled rivet holes in the roll bar and splice.
U
SE CARE TO NOT BEND OR DISTORT THE ROLLBAR
13. Attach the roll bar half to the splice using four (4) 3/16" pop rivets.
NOTE: If the rivets holes are slightly misaligned, use a #10 drill bit and ream the holes to allow
the pop rivet to be pushed in.
14. Unfold the fabric and slide the edge of the fabric (edge with black polycord) into the rollbar. The fabric
can only be inserted from the left side of the rollbar.
15. (Detail C) Center the fabric on the roll bar and secure using two (2) #6 x 3/8 phillips head screws
through the polycord and rollbar. Do not put the screws through the fabric.
16. Roll the fabric onto the rollbar. The fabric must be oriented around the roll bar as shown.
17. (Detail D) Slide the white polyrod and fabric into the awning rail adaptor. Ensure that the two halves of
the adaptor are pushed together (no gaps). Center the fabric over the room.
18. Roll up the slack material onto the roll bar.
19. Slide the right end of the roll bar into the right end cap then set the left end of the roll bar into the left
end cap. Attach with one (1) 1/4-20 x 3/4 socket head screw through the left end cap.
20. Remove the spring locking pin from the roll bar.
21. Open and close the room to ensure that the fabric is rolling up
straight on the rollbar.
22. Secure the adaptor in the awning rail. On each end, place a #6
x 3/8 screw through the awning rail on the outer edge of the
adaptor (not through the adaptor).
23. Secure the fabric to the adaptor using two #6 x 3/8 screws
through the adaptor and fabric.
B A
OLL AR SSEMBLY
Roll Bar Splice
Rail Adaptor
Right Side
(With Sprockets)
1/4-20 x 3/4
Screw
Figure 24. Installing the Roll Bar Assembly.
CARE TO NOT DAMAGE THE ENDCAP
Awning Rail
B
Detail
Rail Adaptor
(ref)
CAUTION
. I
F IT IS NECESSARY TO TAP THE END OF THE ROLL BAR
.
#6 x 3/8
Screw
Figure 25. Securing the Rail Adaptor.
17
Roll Bar Assy
A
D
Detail
Awning Rail
Rail Adaptor
1"
Fabric
052520-001r17
Table of Contents
S
UMMIT
SOK3033
,
USE
SOK3034