Perform A Database Backup; Precautions Against Static Electricity; Before Turning Off Power; Figure 1. Usb/Ethernet Board - V-R Thumbdrive Port - Veeder-Root TLS-450 Upgrade Instructions

Perform A Database Backup

Precautions Against Static Electricity

Before removing electronic components from their anti-static bags read the following static electricity precautions.
1. Before handling any components, discharge your body's static electric charge by touching a grounded
surface.
2. Do not remove parts from their anti-static bags until you are ready to install them.
3. Do not lay parts on the anti-static bags! Only the insides are anti-static.
4. When handling parts, hold them by their edges and their metal mounting brackets.
5. Avoid touching components or edge connectors that plug into slots and wear the anti-static wrist strap (Part
No. 576010-908) included in your component replacement kit.
6. Never slide parts over any surface.
7. Avoid plastic, vinyl, and Styrofoam in your work area.

Before Turning Off Power

Before powering off the console perform a system backup:
1. Insert the V-R Backup Thumbdrive (P/N 332970-004) in the external USB port on the USB/Ethernet card,
P/N 332913-001 (see item 2 in Figure 1).
NOTE: You will need
the V-R Backup
Thumb drive with the
system backup to
perform a system
restore once the
hardware migration is
completed. The
migration will not be
finalized until a system
restore is performed
as described on Page
20.
1. USB/Ethernet board bracket
2. V-R thumbdrive plugged into USB port
1 2 3 4
3

Figure 1. USB/Ethernet Board - V-R Thumbdrive Port

LEGEND FOR NUMBERED BOXES IN Figure 1
3
1
2
5
3. Comm slot positions (left to
right)