Network Management Interface; Telnet Command Line Interface; Initiating A Telnet Session - Fargo HDP600-LC CR100 User Manual

RESTRICTED USE ONLY

Network Management Interface

The SNMP interface is described below.
Interface Description
•
SNMP
The Ethernet interface is a fully-manageable SNMP agent that supports
MIB-II.
•
The Ethernet interface is MIB II compliant, allowing SNMP managers to
monitor protocol, network and routing statistics.

Telnet Command Line Interface

Initiating a Telnet Session

This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer. Follow these instructions to issue Telnet commands.
Step Description
1 Identify the IP address of your Printer. (Note: See the
address of your
2 Initiate a Telnet session from a DOS window on your PC. At the DOS prompt,
enter telnet [IP Address]
Example: C:\>telenet 192.168.11.12
•
All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.
•
All commands entered will be sent to the Telnet client in the Printer.
3 Enter help or ? to get an on-window list of supported Telnet commands.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
Printer.)
Fargo Electronics, Inc.
Accessing the IP
5-4