Fargo HDP600-LC CR100 User Manual page 394

RESTRICTED USE ONLY
Firmware Updater Application Program (continued)
The Firmware Updater application program is the software required to send Firmware
updates from the computer to the Printer. To download and install the Firmware Updater
from this site, refer to the following steps (using Step 1A or Step 1B as appropriate):
Step Procedure
3 a. Once the file has been downloaded, navigate to the location where the
file was saved. The Firmware Updater program has been compressed for
ease of downloading.
b. Decompress the file by double-clicking on the UPDATER.EXE icon.
4 Double-click on the SETUP.EXE file to launch the Firmware Updater Setup
Program
5 Follow the on-screen instructions to complete installation. Once installed, the
Firmware Updater icon will appear in the Start/Programs/Fargo folder.
6 Select the Firmware Updater icon displayed below to open the Firmware
Updater application program.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
Fargo Electronics, Inc.
12-2