Satel ETHM-A Quick Installation Manual

Satel ETHM-A Quick Installation Manual

Universal monitoring module
Hide thumbs Also See for ETHM-A:

Advertisement

Quick Links

ETHM-A
Universal monitoring module
Quick installation guide
Full manual is available on www.satel.eu
EN
Firmware version 1.00
ethm-a_sii_en 10/21
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND
tel. +48 58 320 94 20
www.satel.eu

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ETHM-A and is the answer not in the manual?

Questions and answers

Summary of Contents for Satel ETHM-A

  • Page 1 ETHM-A Universal monitoring module Quick installation guide Full manual is available on www.satel.eu Firmware version 1.00 ethm-a_sii_en 10/21 SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND tel. +48 58 320 94 20 www.satel.eu...
  • Page 2 The rating plate of the device is located on the enclosure base. FreeRTOS is used in this device (www.freertos.org). SATEL aims to continually improve the quality of its products, which may result in changes in their technical specifications and software. Current information about the changes being introduced is available on our website.
  • Page 3 This manual describes how the ETHM-A module should be installed. For further information related to the module, including its configuration and operation, please refer to the full version of the manual, available at www.satel.eu. 1. ETHM-A module installation The device is designed to be used only in the local area networks (LAN). It must not be connected directly to the public computer network (MAN, WAN).
  • Page 4 2. Connect the devices which are to be controlled by the module to the output terminals. 3. If the module is to be powered from the SATEL APS-15 or APS-30 power supply unit, you can connect to the AC input terminal the wire from the secondary winding of the transformer which supplies the AC voltage to the power supply unit (fig.
  • Page 5 Connecting the power supply and starting the module The module may be powered from the control panel, from an expander with power supply, or from a power supply unit. SATEL offers power supplies (e.g. APS-412), which can be connected to the APS connector on the electronics board.
  • Page 6  configure the module by using the GX Soft program. Download the GX Soft program from www.satel.eu. Required program version: 2.0 (or newer). See full manual for more information.  update the module firmware (see full manual).

Table of Contents