Emission Compliance; Safety Warnings - SolarEdge SE K Series Installation Manual

2 Emission Compliance

Emission Compliance

This equipment has been tested and found to comply with the limits applied by the
local regulations.
These limits are designed to provide reasonable protection against harmful interference.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, you are encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance may void the user's authority to operate the equipment.

Safety Warnings

Please review the following safety guidelines, and observe them when handling the
equipment.
Always power down the inverter before opening the unit. Perform the following
steps:
Switch the inverter's ON/OFF switch to OFF, and wait five minutes for the
capacitors to discharge
Cut off AC power to the inverter by turning off the circuit breakers on the
distribution panel.
Turn the DC Safety Unit's switch (if applicable) to OFF.
Three Phase Inverters with Synergy Technology