Emission Compliance - SolarEdge Inline Energy Meter Installation Manual

2 Emission Compliance

Emission Compliance

This equipment has been tested and found to comply with the limits applied by the
local regulations.
These limits are designed to provide reasonable protection against harmful interference.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, you are encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance may void the user's authority to operate the equipment.
CAUTION!
Where EN55011 Class A is deemed applicable, the following requirements apply:
This equipment is not intended for use in residential environments and may
not provide adequate protection to radio reception in such environments.
This equipment should be connected to inverters with a rated power > 20
kVA and is intended to be installed in a large photovoltaic power generating
system by a professional.
This equipment should be physically separated from residential
environments by a distance greater than 30 m, and can be equipped with
additional filtering if necessary.
Inline Energy Meter with SolarEdge Energy Net Communications