To connect the Ethernet cable:
1. Remove of the cover of the communication board compartment.
2. Remove the nut of the COMM1 gland.
CAUTION!
The gland includes a rubber waterproof fitting, which should be used to
ensure proper sealing.
3. Insert the CAT6 Ethernet cable through the gland nut.
4. Remove the rubber fitting.
5. Remove the plastic seal from the rubber fitting.
6. Route the LAN cable through the gland opening in the Synergy Manager.
7. Insert the CAT6 Cable through the cut in the rubber fitting.
Three Phase Inverters with Synergy Technology
Chapter 6: Setting Up Communication with the Monitoring Platform
55