Table of Contents Revision History ....................1 Introduction ....................1 1. Specifications ..................... 2 2. Overview ......................3 2.1. Name of Parts .......................3 2.2. User Interface .......................3 2.3. Power Configuration ....................4 2.4. Signal Configuration ....................4 2.5. EEPROM Jumper (JP3) ..................4 3.
Page 3
HuMANDATA will revise the diagram. When a problem can be solved only by replacing components or modifying the product, HuMANDATA will take back the product to replace it with a properly functioning product.
Aug. 4, 2009 Initial release Introduction Thank you for buying our product USB-103. This is an evaluation board equipped with a FTDI FT2232H, power, reset, and crystal circuit and an EEPROM for device configuration. It can provide you with very convenient and easy-to-use environment.
2.480" x 1.575" (63 x 40 [mm]) Weight 20 [g] typ. 22-pin through-hole User I/O Connectors dia. 0.9 [mm], 100[mil]/2.54 [mm] pitch Accessories DIL 22-pin header RoHS Compliance * There may be cases when compatible parts are used. USB-103 v1.0...
* For details of operation modes, please refer to the FT2232H data sheet. 2.5. EEPROM Jumper (JP3) Please open this jumper “JP3” if you don’t want to use the EEPROM. When used without the EEPROM (or the EEPROM is blank) the FT2232 defaults to dual asynchronous serial port device. USB-103 v1.0...
3.3. Program Application Please use “MPROG” distributed by FTDI. MPROG targets all FTDI devices that connected to PC. When you operate, make sure that other FTDI devices are not connected to your PC. (MPROG Ver.3.5) USB-103 v1.0...
The device driver is not attached. Please download and install the latest one from FTDI’s web site. http://www.ftdichip.com/ 5. Additional Documentation and User Support The following documents and other supports are available at http://www.hdl.co.jp/en/spc/USB/usb-103/ Circuit Schematic Dimensional drawing PCB drawing Net List … and more. USB-103 v1.0...
Page 10
FT2232H Evaluation Board Single Type USB-103 User’s Manual Ver. 1.0 ..........Aug. 4, 2009 HuMANDATA LTD. Address: 1-2-10-2F, Nakahozumi, Ibaraki Osaka, Japan ZIP 567-0034 Tel: 81-(0)72-620-2002 (Japanese) Fax: 81-(0)72-620-2003 (Japanese/English) URL: http://www.hdl.co.jp/en/ (Global) http://www.hdl.co.jp/ (Japan)