Unpacking; Mounting Hardware Required - Varifan DIP-1C Installation & User Manual

DIP-1C INSTALLATION
This section will inform the electrician on proper wiring and installation
procedures for the DIP-1C.
The manufacturer recommends that the following installation instructions to be
followed as closely as possible, and that all work be performed by a certified
electrician. Failure to do so may void the warranty.

Unpacking

Unpack the DIP-1C and inspect contents for damage. Should the contents
appear to be damaged, contact your local distributor to return the equipment.
The package should contain the following standard items:
1 DIP-1C Module
4 Brackets / 4 Screws
1 Installation / User's Guide

Mounting Hardware Required

This is the list of the mounting hardware needed, which is not included with the
product:
Shielded two-wire twisted pair cable, AWG #22 (used for communication) see
electrician note for capacitance selection.
4 screws (to hang the unit onto the wall).
Screwdrivers.
Soldering iron kit or approved sealed connectors.
Drill and hole saw kit
Section B-8
www.monitrol.com
DIP-1C