Site Preparation
Preparation
Uncrate the unit and inspect for damage. Remove the
wood base and discard the shipping bolts and brackets.
Remove and recycle packing materials. Do not discard the
kickplate, anti-tip bracket, and hardware.
Remove the kickplate by extracting the two mounting
screws. Refer to the illustration below.
SCREW
Kickplate removal
6 | Sub-Zero Customer Care 800.222.7820
Anti-Tip Bracket
WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
The back of the anti-tip bracket must be installed 24"
from the front of the unit (without panels). Use all the anti-
tip bracket hardware as instructed for wood or concrete
floors.
IMPORTANT NOTE: For wood or concrete floor applica-
tions, if the #12 screws do not hit a wall stud or wall plate,
use the #8 screws and #12 washers with the wall anchors.
IMPORTANT NOTE: In some installations, the subflooring
or finished floor may necessitate angling the screws used
to fasten the anti-tip bracket to the back wall.
ANTI-TIP HARDWARE
1
Anti-tip bracket
12
#12 x 2 1/2" pan head screws
4
3/8"–16 x 3 3/4" wedge anchors
12
#12 flat washers
4
#8–18 x 1 1/4" truss head screws
4
Nylon Zip-it
®
wall anchors
(610)