Panels - Sub-Zero Designer Series Installation Manual

Panels

Custom Panels
Custom door/drawer panels and handle hardware must
be installed. Stainless steel panels are available through an
authorized Sub-Zero dealer. For local dealer information,
visit the find a showroom section of our website,
subzero.com.
The thickness of the custom panel can vary. A minimum
5/8" thick panel is required, but the thickness can be
(16)
increased provided it does not exceed the maximum panel
weight indicated in the chart below. The depth of each
model is 24" . Allow for panel thickness when planning
(610)
the finished opening depth.
PANEL REQUIREMENTS
WEIGHT PER PANEL
Door (column model)
Door (tall model)
Drawer
PANEL THICKNESS
All Panels
10 | Sub-Zero Customer Care 800.222.7820
Reveals between panels can vary, 1/8"
CAUTION
When installing a panel thicker than 1"
door stop may be required to prevent damage to the
unit and adjacent cabinetry.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while the door is
closing.
Finish all sides of the custom panels. They will be visible
MAX
when the door is open.
35 lb
(16 kg)
25 lb
(11 kg)
D-style handles are recommended. Locate the door
15 lb
(7 kg)
handle near the edge of the panel opposite the hinge and
MIN
centered top to bottom. Locate the drawer handles near
5/8"
(16)
the top edge of each panel. Stainless steel tubular and
pro handles are avail able through an authorized Sub-Zero
dealer. For local dealer information, visit the find a show-
room section of our website, subzero.com.
reveals are typical.
(3)
, the 90°
(25)