Preparation; Anti-Tip Bracket - Sub-Zero Designer Series Installation Manual

Site Preparation

Preparation

Uncrate the unit and inspect for damage. Remove and
recycle packing materials. Do not discard the kickplate,
anti-tip bracket, and hardware.
Remove the kickplate by extracting the two mounting
screws. Refer to the illustration below.
SCREW
Kickplate removal

Anti-Tip Bracket

WARNING
To prevent the unit from tipping forward, the anti-tip
bracket must be installed.
The anti-tip bracket should be attached to the wall behind
the unit with the bracket flange located 1/4"
top of the unit. Refer to the illustration below. Failure to
properly position the anti-tip bracket will prevent proper
engagement.
ANTI-TIP
BRACKET
1
/ "
4 (6)
Anti-tip bracket
above the
(6)
subzero.com | 7