Sub-Zero Designer Series Installation Manual page 15

Installation
Completion
KICKPLATE INSTALLATION
Position the kickplate and install using the two mount-
ing screws. Refer to the illustration below. Kickplate must
be removable for service. The floor cannot interfere with
removal.
A maximum 6" decorative kickplate can be attached
(152)
to the factory-installed kickplate. The two rows of vented
louvers can be covered if the door panel is a minimum 4"
from finished floor.
(102)
To install a decorative kickplate, remove the paper backing
from the magnets and attach the decorative kickplate to
the magnets. The magnets allow the decorative kickplate
to be removed if necessary.
Turn power on by touching "power" on the control panel.
MAGNET SCREW
Kickplate installation
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
90° DOOR STOP
A 105° door stop is built into the hinges. To limit the door
swing to 90°, open the door slightly less than 90°, then use
a standard screwdriver blade to remove the existing clips
from each hinge. Locate the 90° clips from inside the plas-
tic bag containing the product literature, then insert the
90° clips onto each hinge. Refer to the illustration below.
WARNING
Follow all city and state laws when storing, recycling,
or discarding unused refrigerators and freezers.
CLIP
90° door stop
subzero.com | 15