Refer to the illustration below. IMPORTANT NOTE highlights information that is especially Preparation important. If service is necessary, contact your authorized Sub-Zero dealer. Anti-Tip Bracket CAUTION indicates a situation where minor injury or prod- uct damage may occur if instructions are not followed.
Site Preparation Opening Dimensions Electrical Requirements DESIGNER SERIES UNDERCOUNTER WINE MODELS The depth of each model is 587 mm. Allow for panel thick- Installation must comply with all applicable electrical CAUTION ness when planning the finished opening depth. A mini- codes and be properly grounded (earthed).
Site Preparation Preparation Anti-Tip Bracket 90° Door Stop Placement Uncrate the unit and inspect for damage. Remove and The door stop pins provided with the unit limit the door WARNING CAUTION recycle packing materials. Do not discard the kickplate, swing to 90°. To prevent the unit from tipping forward, the anti-tip Before moving the unit into position, secure the door anti-tip bracket, and hardware.
Door Panel Installation Custom Panel Panel Installation TOE KICK CLEARANCE MAXIMUM DOOR OPENING DOOR PANEL INSTALLATION DOOR PANEL ADJUSTMENT The height of the toe kick area can extend beyond the As the panel width and/or depth increases, so does the Typical panel dimensions are based on an 876 mm finished Close the door.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove &...
Page 8
SUB-ZERO, INC. P.O. BOX 44848 MADISON, WI 53744 USA SUBZERO.COM 800.222.7820 9042183 REV-A 10 / 2020...
Need help?
Do you have a question about the Designer Series and is the answer not in the manual?
Questions and answers