Custom Panels - Sub-Zero IW-18 Installation Manual

PANEL INSTALLATION

Custom Panels

Custom door/drawer panels and handle hardware must
be installed. Stainless steel panels are available through an
authorized Sub-Zero dealer. For local dealer information,
visit the find a showroom section of our website,
subzero.com.
The thickness of the custom panel can vary. A minimum
5 / " thick panel is required, but the thickness can be
(16)
8
increased provided it does not exceed the maximum panel
weight indicated in the chart below. The depth of each
model is 24" . Allow for panel thickness when planning
(610)
the finished opening depth.
PANEL REQUIREMENTS
PANEL WEIGHT
Door
Door (IW-30R)
Drawer
PANEL THICKNESS
All Panels
|
10 Sub-Zero Customer Care 800.222.7820
Reveals between panels can vary,
CAUTION
When installing a panel thicker than 1"
may be required to prevent damage to the unit and
adjacent cabinetry.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while door is closing.
Finish all sides of custom panels. They will be visible when
MAX
the door is open.
35 lb
(16 kg)
D-style handles are recommended. Stainless steel tubular
25 lb
(11 kg)
15 lb
(7 kg) and pro handles are avail able through an authorized
Sub-Zero dealer. For local dealer information, visit the find
MIN
a showroom section of our website, subzero.com. Door
5 / "
(16)
8
handles must be located near the edge of the panel oppo-
site the hinge and should be centered top to bottom. Drawer
handles must be located near the top edge of each panel.
1
/ " reveals are typical.
(3)
8
, the 90° stop
(25)