Panels - Sub-Zero Designer Series Installation Manual

Installation
Custom Panels
Custom door/drawer panels and handle hardware must
be installed. Stainless steel panels are available through an
authorized Sub-Zero dealer. For local dealer information,
visit the find a showroom section of our website,
subzero.com.
The thickness of the custom panel can vary. A minimum
16 mm thick panel is required, but the thickness can be
increased provided it does not exceed the maximum panel
weight indicated in the chart below. The depth of each
model is 610 mm. Allow for panel thickness when planning
the finished opening depth.
PANEL REQUIREMENTS
WEIGHT PER PANEL
Door (column model)
Door (tall model)
Drawer
PANEL THICKNESS
All Panels
Reveals between panels can vary, 3 mm reveals are typical.
CAUTION
When installing a panel thicker than 25 mm, the 90°
door stop may be required to prevent damage to the
unit and adjacent cabinetry.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while the door is
closing.
Finish all sides of the custom panels. They will be visible
MAX
when the door/drawer is open.
16 kg
11 kg
D-style handles are recommended. Locate the door
7 kg
handle near the edge of the panel opposite the hinge and
MIN
centered top to bottom. Locate the drawer handles near
16 mm
the top edge of each panel. Stainless steel tubular and
pro handles are avail able through an authorized Sub-Zero
dealer.
DOOR PANEL HEIGHT
The height of the custom door panel can extend beyond
the typical panel height, provided it does not exceed the
weight limit. Refer to the illustration below.
45
mm
A DECORATIVE VALANCE
CANNOT EXTEND
3 mm BEYOND THIS PLANE
DOOR
PANEL
2134 610 mm
mm
TO BACK OF UNIT
HINGE
Upper valance (side view)
TOE KICK CLEARANCE
The height of the toe kick area can extend beyond the
typical toe kick height, provided it does not exceed the
dimensions in the illustration below. Toe kick heights from
51 mm to 98 mm require a reduced toe kick accessory
available through an authorized Sub-Zero dealer.
**
HINGE VENTED
LOUVERS
610 mm
TO BACK OF UNIT
DOOR
PANEL
29 mm
MAX
TOE KICK
ADJUSTMENT
51 mm*
A DECORATIVE TOE KICK
TO
152 mm CANNOT EXTEND
FROM BEYOND THIS PLANE
FLOOR
*51 mm to 98 mm requires sales accessory.
**Column models only.
Toe kick (side view)
subzero.com | 7