Downloading The Vfc400-Usb To Control Solutions Vtmc; Re-Deploying The Vfc400-Usb - CONTROL SOLUTIONS LogTag VFC400-USB Product User Manual

Plugging the VFC400-USB into a USB port

Downloading the VFC400-USB to Control Solutions VTMC

Occasionally, you will want to download the recorded data to Control Solutions VTMC for
additional analysis.
You can either do this by opening the on-board file that was generated when you
connected the unit to your PC, or by directly downloading the unit while it is connected
to your computer.
Note that Control Solutions VTMC only works on computers using a Windows OS,
but not on macOS or Linux.
To view the data on your PC, do the following steps:
Start Control Solutions VTMC.
l
Click Download
l
saved to your computer as a *.ltd, and a chart with the readings will be presented.
You can switch the way the data is displayed using the tabs at the bottom of the
l
window, upload them to LogTag Online or export the data to different file formats.
For more information about using Control Solutions VTMC please see the section
about Analyzing Data

Re-deploying the VFC400-USB

Once you have finished analyzing the data, re-deploy the logger to the installation site:
If the logger is already configured for continuous logging, no further configuration
l
is required. If you wish to start a new trip, re-configure the device by following the
instructions in the section about
treat the logger the same as if it were unconfigured.
Once the unit is configured, continue the steps in the
l
preparation.
Control Solutions VTMC can be set up so these steps are automated. Please refer to the
Control Solutions VTMC User
VFC400-USB User Guide
from the Control Solutions
in the Control Solutions VTMC User
Configuring the VFC400-USB for
Guide, specifically to the section about Automation.
menu. The data from the logger is now
Guide.
On-site section of the logger
53
logging, and