Plugging The Vfc400-Usb Into A Usb Port - CONTROL SOLUTIONS LogTag VFC400-USB Product User Manual

Plugging the VFC400-USB into a USB port

channel, but the audible alarm and the alarm LED will turn off (see exception
below).
If an ALARM is present ( ) and the
function is enabled, you will need to clear the alarm first before you can stop the
logger. Please see
will be shown for the alarm status once the logger has stopped.
Plugging the VFC400-USB into a USB port
What happens when you plug your VFC400-USB into a USB port depends on the
operating system of the computer, the settings made during configuration and whether
or not Control Solutions VTMC is running.
Microsoft Windows
Several drivers will now be installed, depending on the VFC400-USB's configuration.
All drivers are part of the operating system and will typically not require administrator
privileges for your computer. During driver installation you will see the familiar
Windows notification.
Drivers that are installed may include the following:
Mass Storage Device Driver
l
LogTag Mass Storage USB Device Driver
l
These two devices are required so you can access the data files in the same way as a
USB memory stick. These drivers will not be installed if the VFC400-USB does not
generate files.
USB Input Device (HID) Driver
l
This device is used for communication to Control Solutions VTMC and its driver will
always be installed, even if Control Solutions VTMC is not present on the
computer.
USB Composite Device Driver
l
This driver signals that multiple devices are involved when plugging in a
VFC400-USB.
If you have configured the VFC400-USB to
time you plug the logger into the USB port. While the file creation takes place, the
display shows bUSy instead of the current time.
VFC400-USB User Guide
Clear alarm by pressing STOP button
Clearing an Alarm for more information. In this case, a tick
generate files, these will be created every
50